ARE YOU LOOKING FOR RELIABLE UNIT 2 INTERPRETING AND USING ENGINEERING INFORMATION ASSIGNMENT HELP SERVICES? MIRACLESKILLS.COM IS RIGHT CHOICE AS YOUR STUDY PARTNER!
Qualification - BTEC Level 2 Diploma In Engineering
Unit Name - Interpreting and Using Engineering Information
Unit Number - Unit 2
Assignment Title - Engineering Drawings and Documentation
Level - Level 2
Case Scenario:
Consider yourself a junior mechanical engineer in production department of a factory, your supervisor has asked you to assist him in documentation process to show your qualifications in achieving related Assignment Tasks.
Engineering drawings and Information had received to be checked, analysed, and explained for the workers and technicians to carry out manufacturing processes appropriately.
Assignment Task 1
You are given a drawing. The drawing's title is "Aligned Shaft, Date: 10/01/07"
The drawing shows a shaft connected to a base at the flange. This is identified as (A) on the individual drawings for each component.
a. Calculate the total height of the assembled components.
b. Which size bolts are used to assemble the products and what is the tap drill size for it?
c. If the shaft is made to its biggest diameter and the hole in the base is made to its smallest diameter, what clearance will there be between the shaft and the hole?
Criteria reference
P1 Extract suitable information from engineering drawings and related documentation to enable a given Assignment Task to be carried out.
GET ASSURED A++ GRADE IN EACH BTEC LEVEL 2 DIPLOMA IN ENGINEERING ASSIGNMENT ORDER - ORDER FOR ORIGINALLY WRITTEN SOLUTIONS!
Assignment Task 2
Study the two main components that make up the product shown in the drawing in Assignment Task 1. Identify any reasons why the product could not be made using this drawing. This may be because important information is missing.
Write down three reasons why the product could not be made because of missing or deficient information.
Criteria reference
M1 Explain gaps or deficiencies in the information obtained that need to be resolved to enable a given Assignment Task to be carried out.
Assignment Task 3
Where you have found that information is missing from the drawing in Assignment Task 1, identify solutions.
a. Write down the solutions you have decided on for each missing piece of information and show how these should be marked on the drawing.
b. The two sections of shaft at (B) need to be concentric with each other, within 0.02 mm. Show on the drawing how this geometric tolerance should be represented.
Criteria reference
D1 Justify valid solutions to meet identified gaps or deficiencies with the information obtained.
GET WELL WRITTEN UNIT ASSESSMENT SOLUTION USING UNIT 2 INTERPRETING AND USING ENGINEERING INFORMATION - BTEC DIPLOMA IN ENGINEERING ASSIGNMENT HELP!
Assignment Task 4
The sketch of the electrical circuit drawing shown below needs to be converted into an electrical engineering drawing.
Research standard symbols used in electronic engineering, then produce a new circuit drawing using standard electronic component symbols.
Criteria reference
P3 Select other information sources to support and check engineering drawings and related documentation.
Assignment Task 5
When you are working with drawing and documentation, you need to take good care of the documents.
a. Describe the care that must be taken when handling drawings, from removal from files to return to files.
b. Describe the importance of safe storage of documents such as job cards.
c. Describe some security features that may be used to protect documents in a drawing office.
Criteria reference
M2 Specify the care and control procedures for the drawings and related documentation used when carrying out and checking own work output.
SAVE DISTINCTION MARKS IN EACH BTEC LEVEL 2 DIPLOMA IN ENGINEERING ASSIGNMENT WHICH IS WRITTEN BY OUR PROFESSIONAL WRITER!